logo  
 
 
               
 
 
 
 
 
 
   
 
 
How to press
 
1. Each transfer is completely ready to iron-on. Preheat your Iron to the proper temperature for your fabric.
 
2. Slowly pull off the protective whitebacking and discard.
 
3. Place the transfer - sticky side down onto the garment. Make sure it is exactly where you want it to be.
 
 
4. Place the iron directly onto the clear film. Allow it to remain in place for at least 20 seconds before moving.
 
 
5. Lift straight up several times
during the application to make sure the solid part of the soleplate in on the design. Where there are steam vents there is no heat.
 
 
6. Allow to cool and slowly remove the adhesive film. Repress from back side of the of fabric. If any trims remain on the film, replace film and
repeat steps above.
Press condition
1. Material Type : Cotton, Denim materials and etc.
 
  FRONT SIDE BACK SIDE
PRESSURE (kg) 2.8~3.2 2.8~3.2
TEMPERATURE (กษ) 150~170 150~170
TIME (seconds) 10~20 7~12
 
2. Conditions of Pressing Mixed Type of Hot Fix Items
 
  FRONT SIDE BACK SIDE
PRESSURE (kg) 3.0~3.5 3.0~3.2
TEMPERATURE (กษ) 150~180 150~180
TIME (seconds) 15~20 10~15
 
3. Conditions for Pressing Rhinestones
 
  FRONT SIDE BACK SIDE
PRESSURE (kg) 2.8~3.5 2.8~3.0
TEMPERATURE (กษ) 150~180 150~170
TIME (seconds) 15~20 7~12
 
4. Conditions for Pressing Iron on Studs and Rhinestones
 
  FRONT SIDE BACK SIDE
PRESSURE (kg) 2.8~3.2 2.8~3.2
TEMPERATURE (กษ) 150~180 150~170
TIME (seconds) 10~15 7~12
 
5. Conditions for Pressing Pearls and Glitters
 
  FRONT SIDE BACK SIDE
PRESSURE (kg) 2.8~3.0 2.8~3.0
TEMPERATURE (กษ) 150~180 150~180
TIME (seconds) 13~18 12~15
 
Additional notice
 
  1. Take projecting buttons, zippers and other thick sections into consideration!
  2. Thin fabrics(organza) do not absorb the adhesive well.
  3. Always allow the carrier foil to cool off completely before removing it!
  4. If impressions have already been caused by foil, brushing, steaming or applying the heat press once more, regenerates the fabric structure.